Insert your flash drive and open USBView 8. Open the file xbreader.inf (located in the Drivers subfolder of the Action replay install folder) in your favorite text editor. scroll down until you see "Action Replay XBox PC Software v1.31" in bold on the left-hand side 4c.
If you wish to transfer files from PC to XBox, continue. If you only need it for XBox use, you're done. The XBox will format it as FATX (all data will be erased) 3. Format the drive by inserting it into the adapter and attempting to read it's contents. Check drive compatability at some drives simply will not read 2. connecting accessories to my xbmc If you are planning to use a USB Flash Drive as a memory card, here are some quick steps: 1. Softmodding without an action replay or card 3. Xbox memory cards are too small, and I liked the Idea of 1gig of gamesaves 2. test your connections before you go any further. Short the ground pin to the metal shield of the XBox connector (this corrects lots of connection issues). now here's the secret I didn't learn until late in the process. solder the connectors together, following the diagram bend the supports and shield, so they form some semblance of structural integrity, and solder them in place. looking down from the top, bend the left most pin slightly to the left, and the other three pins slightly to the right, to make room for the unused pin. first, bend all four pins on the USB Connector to face outward from the back of the connector. I'll include a diagram below, but the big thing to remember is: skip the pin that had the yellow wire, and don't short it (the yellow wire apparently carries 12 volts. It is relatively well known that XBox controller ports are essentially USB ports, so the connection is simply wire to wire.
0 kommentar(er)
